Handheld 4G Cell Phone Jammer Work

In recent years, mobile phone signal jammers have become more and more common in people’s daily life, but do you know Handheld 4G Cell Phone Jammer Work When assembling, how to install it to stimulate its application effects? The components of mobile phone signal jammers generally include: server, wireless Antenna, adapter. When installing a mobile phone jammer, because there is a very strong electromagnetic field for data signals within a certain distance between the server and the wireless antenna (generally 20-30 cm), and at the same time, there is also near the 220V power plug (weak current) (generally 5-10 cm). The electromagnetic field affects, therefore, cell phone jammer How to arrange the assembly part of each component is very important. If the placement part is wrong, it is very likely that the transmission of the shielded data signal will be affected and the actual shielding effect will be compromised.

The adapter should avoid the server 20cm above; (If Handheld 4G Cell Phone Jammer Work is assembled, due to the installation conditions of the site, it is not guaranteed to avoid the switching power supply. The adapter can be placed under the mobile phone jammer server. After selecting this method, the adapter There will still be some influence from the magnetic field of the mobile phone jammer server, which will be less affected than if the adapter is close to the two sides of the server.) There is no weak circuit line (AC220V) within 20cm of the wireless antenna; (including The upper and lower sides of the wireless antenna, the upper side of the wireless antenna, the weak electric wires of the embedded parts of the wireless antenna’s geographical position, etc., if it cannot be placed, please try not to place it within 10cm of the wireless antenna.) When the distance between the safe part and the communication base station is less than 200 meters, the actual shielding effect It is inversely proportional to the distance from the communication base station. That is, the closer the communication base station, the smaller the shielding radius. Tighten the wireless antenna before plugging in. The wireless antenna must be upright (⊥). The data marked on the wireless antenna must correspond to the data marked by the wireless antenna hole on the server. There is no need to plug in the wrong way, let alone connect the wireless antenna. At the same time, power on the chassis.